Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wind transducer setup
04-18-17, 07:55 PM
Post: #15
RE: wind transducer setup
Hello again Chuck. I finally got up the mast and pulled the transducer. I unscrewed the connection to the base and when I pulled the the transducer off I noted the plug and terminals were wet. Since this is inside the plug and there is an O ring beneath the screw-on connector I thought this should not be wet.

Would water inside the connector cause the symptoms I was experiencing? Or is it normal to find wetness inside this fitting?

Thanks, Charlie
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
wind transducer setup - charlie98117 - 01-09-17, 01:47 PM
RE: wind transducer setup - charlie98117 - 04-18-17 07:55 PM
wind transducer setup - Marcmmm - 12-04-17, 10:56 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us