Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
x30 and ST6002
02-10-17, 10:43 AM (This post was last modified: 02-13-17 11:08 AM by Chuck - Raymarine - Moderator.)
Post: #5
RE: x30 and ST6002
Chuck,
The example I sited heading in AUTO mode 288, COG on chart plotter varied between 286 -290, BTW on ST6002 189.

I have not found a converter. I can tell you that all of the cables to the X30 terminate at the Sea Talk terminal.

I have a mixed system. The chart plotters are Garmin but wind, depth, and speed instruments along with auto pilot are Raymarine.

The controller software is version 5.00 and X30 is 300.

I cannot find a converter anywhere, just a E85001 interface. All of the cables that connect to the X30 are on the Sea Talk terminal. The lower one,
there is no Sea Talk plug. I have 2 Garmin Chartplotter units but the wind, speed, depth and auto pilot are Raymarine. All of the information across all units matches except for the BTW when displayed on the ST6002.

The track mode has never worked well. It always makes a huge turn on way or the other even if the boat is right on course to the next waypoint. I just started checking the data pages on the ST6002 and found this problem.
Ted
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
x30 and ST6002 - Ted - 02-08-17, 01:40 PM
RE: x30 and ST6002 - Ted - 02-08-17, 06:14 PM
RE: x30 and ST6002 - Ted - 02-10-17 10:43 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)