[CA] [CA11] ST60 wind, tested voltage

[Chuck - Raymarine - Moderator]

gk1978c34,

As you have suggested, no voltage should be measured on the ST60 Wind Instrument's yellow transducer terminal when the transducer leads have been disconnected from the instrument. The symptom reported would be indicative of a failure of the instrument. Unfortunately, Raymarine can no longer service ST60/ST60+ instruments, necessitating its replacement. If seeking a drop-in replacement, then an i60 Wind Instrument may be used. The i50/i60 instruments may be adapted to be interfaced to an existing SeaTalk bus by unplugging the SeaTalk Cable(s) which is connected to the instrument and connecting it/them to a D244 SeaTalk Junction Block. An A06047 / 15.7in (0.4m) SeaTalkng to SeaTalk Cable may then be used to connect the i50/i60 instrument to the aforementioned D244 SeaTalk Junction Block.