(DG) ST4000+ and 10 Hz sensor

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

(DG) ST4000+ and 10 Hz sensor

02-07-18, 10:02 AM

Post: #2

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: (DG) ST4000+ and 10 Hz sensor

Hi vshtonov
Thank you for your enquiry.

The ST4000+ will not benefit from the 10Hz heading sensor and there is no point connecting it to the unit. it will only use the Fluxgate coils connected directly to the rear of the ST4000+control unit.

The ST4000+ will not operate if the fluxgate is disconnected from it.

Regards

« Next Oldest | Next Newest »

Messages In This Thread

(DG) ST4000+ and 10 Hz sensor - vshtonov - 02-06-18, 06:50 PM

RE: (DG) ST4000+ and 10 Hz sensor - Derek - Raymarine - Moderator - 02-07-18 10:02 AM

RE: (DG) ST4000+ and 10 Hz sensor - vshtonov - 02-07-18, 10:34 AM

RE: (DG) ST4000+ and 10 Hz sensor - Derek - Raymarine - Moderator - 02-09-18, 09:53 AM

RE: (DG) ST4000+ and 10 Hz sensor - vshtonov - 04-26-18, 03:04 PM

RE: (DG) ST4000+ and 10 Hz sensor - Derek - Raymarine - Moderator - 04-27-18, 03:47 AM

User(s) browsing this thread: 1 Guest(s)