Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Yellow-plug SeatalkNG to SeaTalk Auxiliary Junction Box
02-20-18, 01:45 PM (This post was last modified: 01-28-19 11:51 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Yellow-plug SeatalkNG to SeaTalk Auxiliary Junction Box
Hello

I'm looking at doing a similar setup as presented in
http://forum.raymarine.com/showthread.php?tid=366

So basically bridging my SeaTalkNG network (most of my components, including an ICT-5) with a Seatalk1 network where I have an ST60-Tridata and ST-Wind operating as slave devices to the network (data acquired and processed by the ICT-5). The 2 networks will be briged using a "Raymarine SeaTalk1 to SeaTalkng converter kit"

My chained ST60-Tridata and ST-Wind was previously connected to my autohelm computer via bare wires.

My question, can I cut the SeaTalk1 press-fit end of a yellow-plug SealTalkNG cable to connect to the Auxiliary Junction Box? What about exposing the bare-wire by cutting the press-fit end of a A06047?

Thank you
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Yellow-plug SeatalkNG to SeaTalk Auxiliary Junction Box - rapscallion2 - 02-20-18 01:45 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us