[CA] Replacing a E7 with a 9" MFD
|
03-14-18, 12:43 PM
(This post was last modified: 03-14-18 12:49 PM by Chuck - Raymarine - Moderator.)
Post: #4
|
|||
|
|||
RE: [CA] Replacing a E7 with a 9" MFD
MPNV,
The CP100 may be interfaced to any of the following MFDs or to an Ethernet network switch (ex. HS5 RayNet Network Switch, SeaTalkhs Network Switch) via an appropriate length of RayNet (F) to RayNet (F) Cable: - Axiom MFD (any model) - Axiom Pro MFD (any model) - gS-Series MFD ((any model which has been updated with the latest LightHouse II or LightHouse 3 software) - eS-Series MFD (any model which has been updated with the latest LightHouse II or LightHouse 3 software) - e-Series MFD (any model which has been updated with the latest LightHouse II software) - c-Series MFD (any model which has been updated with the latest LightHouse II software) - a-Series MFD (any model which has been updated with the latest LightHouse II software) With respect to the CP100, when interfaced to the new MFD, it will support the same sonar imaging (i.e. DownVision and/or High CHIRP conical sonar) as had the e7 MFD. Should RealVision 3D sonar imaging and/or SideVision sonar imaging be desired, then it would be recommended that the system feature Axiom RV MFD or Axiom Pro RVX MFD and a RealVision transducer. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA] Replacing a E7 with a 9" MFD - MPNV - 03-09-18, 01:25 PM
RE: [CA] Replacing a E7 with a 9" MFD - Chuck - Raymarine - Moderator - 03-09-18, 01:54 PM
RE: [CA] Replacing a E7 with a 9" MFD - Chuck - Raymarine - Moderator - 03-14-18 12:43 PM
|
User(s) browsing this thread: 1 Guest(s)