Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] iTC-5 as an interface to ST1 Displays
04-20-18, 09:14 AM
Post: #6
RE: [CA] iTC-5 as an interface to ST1 Displays
Brian,

The diagram is now very close. As the Type 100/300 autopilot course computer did not support outputting 10Hz stabilized heading data from its NMEA 0183 port, there would be no reason to install the Actisense data bridge. The MFD will bridge data between SeaTalk and SeaTalkng for the devices shown within the diagram.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] iTC-5 as an interface to ST1 Displays - Chuck - Raymarine - Moderator - 04-20-18 09:14 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)