Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(DG) When turning auto on it immediately goes into figure 8
06-25-19, 10:01 AM
Post: #3
RE: (DG) When turning auto on it immediately goes into figure 8
Hi Pressonjh,
Thankyou for your enquiry,

Once you have carried out the check s outlined earlier in the thread, with the vessel tied up alongside carry out two simple tests . . .

first with the autopilot in STANDBY mode, turn the steering wheel to port and then Starboard - does the rudder angle display correctly indicate Port and Starboard rudder? If yes, good! if no, turn the power off, swap the red and green wires from the rudder reference unit over and test again to make sure the indication is correct.

Next select AUTO and press 3 x +10 on the autopilot keypad, does the drive turn the rudder to Starboard or to port? If starboard good - if port, turn the power off, swap the MOTOR wires over where they connect into the course computer and then test again.

If the two tests above work OK, then the basic set up of the pilot is correct.

Regards

Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: (DG) When turning auto on it immediately goes into figure 8 - Derek - Raymarine - Moderator - 06-25-19 10:01 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)