[CA] Interfacing a Fusion AV750 to Lighthouse 3

[Dhacker@craworld.com]

ahh, the scenario described is similar to mine, however my setup is not working. What I have:

1. A127 multifunction display
2. Ray60 VHF radio
3. Power connection

All of 1. and 2. and 3. above connected on STNG 5-way connector and working OK. The radio shows Lat/Long etc.

I then extended the STNG with a backbone cable, and T-piece connector plus terminator. this was so that I can connect to a Fusion AV755. I used the 'hard-wired remote' connector on the back of the stereo, connected to a Raymarine A06045 DeviceNet Female adapter cable, (with a spur connector on the other end) to connect to the T-piece.

I am not seeing any connectivity between the units. The radio and A127 are still seeing each other, so I believe that the STNG is operating correctly. On the A127, I go to the Audio icon on the home page, and it advises that no device is present.

Not sure what to check/test further. Any assistance would be appreciated.

tks

Dave