(DG11) Autopilot Display Reading Hard Starboard when rudder centered
|
05-20-18, 03:58 PM
(This post was last modified: 05-21-18 09:42 AM by Derek - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
(DG11) Autopilot Display Reading Hard Starboard when rudder centered
I updated my autopilot to a Raymarine EV100 last year. Worked perfectly. This winter I had the Seastar hydraulic ram replaced (the old one was leaking). The steering works fine but the helm display shows 30 degrees starboard rudder angle when the rudder is centered. I tried going through the set up again but the problem persists (the position of the rudder angle sensor wasn't changed when the new ram was put in and the ram/ tiller arm are parallel when rudder is amidships.
Any thoughts on how to correct this? Thanks. Carl |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
(DG11) Autopilot Display Reading Hard Starboard when rudder centered - upnatum - 05-20-18 03:58 PM
|
User(s) browsing this thread: 1 Guest(s)