[TG11] MFD not discovering other STNG data (...is preventing data source connection)

[RichardSmith]

(05-28-18 11:07 PM)Tom - Raymarine - Moderator Wrote:  Hello Richard,

This is a common misconception. The Data Source selection is only used if you have more than one source of a particular type of data (e.g. two GPS receivers) AND you need to select between those sources. In all other circumstances, you don't need to go in there. The MFD will read whatever's available without having to go in there.

IF you do find that you need to do source selection, you can do so after updating the software in your ST1-STNG convertor (earlier software didn't support data source selection) through your MFD.

If your displays aren't showing any STNG data, the problem is probably that you have the wrong one configured as the Data Master (only the Master reads or transmits STNG data.) The display that's configured as the Data Master needs to be connected to STNG, other displays don't need to be, though we recommend that we are for redundancy.

If you want to do diagnostics and find out what's on the network, that's in Home > Setup > Maintenance > Diagnostics > Select Device.

If the displays are doing something else (e.g. partial or incorrect data), please let me know exactly what is going on.

Regards,
Tom