Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Using proAIS2 with AIS500 transceiver
06-19-18, 10:19 AM
Post: #12
RE: [CA11] Using proAIS2 with AIS500 transceiver
David,

Q. Do I also need to make sure that the AIS unit is NOT connected to any other Raymarine units, even if they are powered off?
A. It should typically be sufficient to ensure that the other devices have been switched off. That said, it can't hurt to disconnect the other device's NMEA 0183 plug.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Using proAIS2 with AIS500 transceiver - Chuck - Raymarine - Moderator - 06-19-18 10:19 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)