The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Axiom, Axiom Pro Fuel Management

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom, Axiom Pro Fuel Management
06-18-18, 01:52 PM (This post was last modified: 06-19-18 01:53 PM by Chuck - Raymarine - Moderator.)
Post: #1
kaptkaos Offline
Junior Member
**
 		Posts: 21
Joined: May 2018
Reputation: 0
[CA11] Axiom, Axiom Pro Fuel Management
I just installed the EC-100 and I can now see engine data on the MFD. However its just mirroring what the Command Link Displays on the gauges as far as MPG which is not accurate because my water speed sensor on the LU is not very accurate. I want the MFD to use the GPS speed and Engine Fuel Data to calculate MPG. Is it possible to change the speed source for the economy or do I have to wire up the NMEA 0183 from the MFD to the Command link and tell the gauges to use my GPS data for speed? I prefer not to have to do that.

THanks
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Axiom, Axiom Pro Fuel Management - kaptkaos - 06-18-18 01:52 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication