Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Converting .fsh to .gpx
07-16-18, 04:30 PM (This post was last modified: 07-16-18 04:32 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Converting .fsh to .gpx
Welcome to the Raymarine Forum fishinhuntinfreak,

The most common cause for the reported issue is that the data within the archive.fsh file violates one or more of the constraints listed within the FAQ found here. If the archive.fsh file was produced by a Raymarine MFD, then it would be recommended that you go back to the MFD and verify that the data for each waypoint does not violate these constraints. If not and the problem persists, then attach the archive.fsh file to a response to this thread for further analysis. If the archive.fsh file was produced by a third party application, then it would be recommended that the data be changed within that applications and that a new archive.fsh file then be produced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Converting .fsh to .gpx - Chuck - Raymarine - Moderator - 07-16-18 04:30 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)