Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG11] Cannot change ST60/ST60+ units to metres
11-29-18, 01:34 PM (This post was last modified: 11-29-18 01:42 PM by Chuck - Raymarine - Moderator.)
Post: #1
[DG11] Cannot change ST60/ST60+ units to metres
I have an A70D (classic) display connected to an ST60 Multi and ST60+ Graphic via an E22158 converter.

The A70D is set to show depth in metres, but I am unable to change the units on either of the displays to metres. They are both stuck on Feet.

If I turn off the power on the A70D then the units can be changed, but as soon as the chartplotter is turned back on, they revert back.

Is this issue being caused by the chartplotter or the converter? Both are on the latest software. Is there any way to fix this?

Thanks in advance
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] Cannot change ST60/ST60+ units to metres - garethreynolds - 11-29-18 01:34 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us