[DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm

02-07-19, 06:29 AM

Post: #4

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm

Hi Billc42

Thank you for your feedback,

Although you do not mention which autopilot system is being used, ir SPX, EVolution etc . . in general the pilot performance may be improved in following seas by increasing the rudder gain and changing the mode type to performance in the EV pilot or equivalent in the earlier models. May also be a good idea to check the deviation measured by the compass - since large compass deviation can impact autopilot performance.

regards

Derek

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm - simon Pachunter - 02-05-19, 08:36 PM

RE: [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm - Derek - Raymarine - Moderator - 02-06-19, 07:35 AM

RE: [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm - billc42 - 02-06-19, 12:27 PM

RE: [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm - Derek - Raymarine - Moderator - 02-07-19 06:29 AM

RE: [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm - simon Pachunter - 02-07-19, 10:16 AM

RE: [DG11] Linear type 2 short or can I use a long with a 10 inch tiller arm - Derek - Raymarine - Moderator - 02-08-19, 05:45 AM

User(s) browsing this thread: 2 Guest(s)