[CA11] Depth over 100M goes back to Zero not ---

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Depth over 100M goes back to Zero not ---

04-10-19, 11:46 AM (This post was last modified: 04-10-19 03:33 PM by Chuck - Raymarine - Moderator.)

Post: #1

Sv Flip-Flops Offline

Junior Member

Posts: 4
Joined: Jan 2019
Reputation: 0

[CA11] Depth over 100M goes back to Zero not ---

I have a P19 depth transducer on the 0183 network going through a SeaTalk Ng converter. Output is via a Axiom 9 and i70.

When in deep water over 100m the depth reading does not display --- instead it goes to a heart stopping low reading of 1-10 meters it will then bounce around what appears to be the depth say in 149m it will display 49m.

Is there a way to stop this and get the system to blank out over 100M or to show 3 digits. This is a new issue in the past 3-4 months.

Thanks for any input.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Depth over 100M goes back to Zero not --- - Sv Flip-Flops - 04-10-19 11:46 AM

RE: [CA11] Depth over 100M goes back to Zero not --- - Chuck - Raymarine - Moderator - 04-10-19, 03:37 PM

RE: [CA11] Depth over 100M goes back to Zero not --- - Sv Flip-Flops - 04-15-19, 09:45 AM

RE: [CA11] Depth over 100M goes back to Zero not --- - Chuck - Raymarine - Moderator - 04-15-19, 03:29 PM

RE: [CA11] Depth over 100M goes back to Zero not --- - Sv Flip-Flops - 04-15-19, 04:06 PM

RE: [CA11] Depth over 100M goes back to Zero not --- - Chuck - Raymarine - Moderator - 04-16-19, 03:41 PM

RE: [CA11] Depth over 100M goes back to Zero not --- - Sv Flip-Flops - 04-16-19, 06:04 PM

RE: [CA11] Depth over 100M goes back to Zero not --- - Chuck - Raymarine - Moderator - 04-17-19, 08:53 AM

User(s) browsing this thread: 1 Guest(s)