[CA11] E-classic engine data display

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] E-classic engine data display

04-11-19, 10:12 AM (This post was last modified: 04-11-19 03:23 PM by Chuck - Raymarine - Moderator.)

Post: #1

lotharjt Offline

Junior Member

Posts: 40
Joined: Feb 2016
Reputation: 1

[CA11] E-classic engine data display

Hi there, these old plotters have a pre-defined engine display for both single and dual engines. What source(s) will the plotter use for the data interface, ie, if the Seatalk NG bus is interfaced to the Seatalk 2 port of the plotter, will it pickup and display engine RPM for example? Or is it only possible via NMEA 0183?

Of course, all assumes the last s/w release is loaded, V5.69

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] E-classic engine data display - lotharjt - 04-11-19 10:12 AM

RE: [CA11] E-classic engine data display - Chuck - Raymarine - Moderator - 04-11-19, 03:29 PM

RE: [CA11] E-classic engine data display - lotharjt - 04-12-19, 07:36 AM

RE: [CA11] E-classic engine data display - Chuck - Raymarine - Moderator - 04-12-19, 07:49 AM

User(s) browsing this thread: 1 Guest(s)