Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Can't Find Transducer on STNG Network
05-21-19, 04:37 PM (This post was last modified: 05-23-19 03:56 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Can't Find Transducer on STNG Network
I recently fired up my network with all of the planned pieces in place. I soon found that the network could not find the analog depth sensor consistently.

My system includes an Axiom MFD on the network, and analog depth and speed transducers connected to an iTC-5, plus a number of other components. When I go to the Network on setup on the Axiom to select the inputs, it finds the iTC-5 with the speed transducer attached. On the second of the five times I tried, it found the depth sensor on the iTC-5, but no joy any of the other times.

The boat is out of the water, and I've checked the connections in the iTC-5 and found no problems there.

Any suggestions on what to try next?

Thanks.

Mark
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Can't Find Transducer on STNG Network - mprestero - 05-21-19 04:37 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us