[TG11] Wind Vane Mounting Orientation

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Wind Vane Mounting Orientation

08-06-19, 04:54 PM

Post: #8

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] Wind Vane Mounting Orientation

The two circles (linearisation) is only performed on first power-on, or after a factory reset. It's only required in a new system or if you replace the windvane. If you wish to do it again then you'll need to do the Factory Reset through the Dealer Calibration menu, described towards the back of the handbook. As I say though, this isn't normally required unless you've replaced the windvane, and does not affect the wind angle alignment.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] Wind Vane Mounting Orientation - mjbowden - 07-17-19, 06:31 AM

RE: [TG11] Wind Vane Mounting Orientation - Tom - Raymarine - Moderator - 07-24-19, 02:47 AM

RE: [DG11] Wind Vane Mounting Orientation - mjbowden - 07-30-19, 02:51 PM

RE: [TG11] Wind Vane Mounting Orientation - billc42 - 07-24-19, 12:51 PM

RE: [DG11] Wind Vane Mounting Orientation - Derek - Raymarine - Moderator - 07-25-19, 07:16 AM

RE: [TG11] Wind Vane Mounting Orientation - Tom - Raymarine - Moderator - 08-04-19, 06:51 PM

RE: [TG11] Wind Vane Mounting Orientation - mjbowden - 08-05-19, 05:15 AM

RE: [TG11] Wind Vane Mounting Orientation - Tom - Raymarine - Moderator - 08-06-19 04:54 PM

User(s) browsing this thread: 1 Guest(s)