[CA] [CA11] New system install

[Chuck - Raymarine - Moderator]

Pawseidon,

Q1. The B60 is currently plugged directly into a DSM30. I will also need a transducer cable extension (about 4 meters) to reach the new Axiom Pro RVX
A1. The E66010 5m Extension is the correct transducer extension cable for 50kHz/200kHz fishfinder transducers which were designed to be directly mated to the Transducer socket of the following fishfinding products (and is correct for your application):
- CP370 Digital Sounder Module
- CP300 Digital Sounder Module
- DSM30/DSM300 Digital Sounder Module
- hsb/hsb2/SL Pathfinder Series Fishfinder Displays

Q2. I want to connect my two old C90W units into a new SeatalkNG network that will have the two new Axiom Pro's, new radar, autopilot and AIS transceiver units. I believe I need the following parts to connect them: E22158, D244, D284 and A06047. Is this correct?
A2. Negative. Like the Axiom MFDs, the C-Series Widescreen MFDs feature a SeaTalkng / NMEA 2000 communications interface. A powered and properly terminated SeaTalkng / NMEA 2000 backbone will be installed onboard. While it would be atypical that C-Series Widescreen MFDs be used within the same system as an Axiom/Axiom Pro/Axiom XL MFD, the Data Master MFD and Data Master Axiom/Axiom Pro/Axiom XL MFD may each be interfaced as spur to the aforementioned backbone. The C-Series Widescreen MFDs would be interfaced to one another via SeaTalkhs Cable to permit them to share cartography and alphanumeric GPS, instrument, depth, navigational, and system state data. More information on this subject may be found within the FAQ referenced in my response to Q3.

Q3. With this connection, will I be able to use the C90W's to view the charts, radar and sonar that are on the new network?
A3. Negative. Please click here to view a FAQ addressing this subject.