[TG] [TG11] ECI-100 compatibility with Etecs
|
10-29-19, 01:02 AM
(This post was last modified: 10-29-19 01:03 AM by Tom - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: [TG11] ECI-100 compatibility with Etecs
Hello dars padilla,
NMEA2000 engine data can be connected directly into the Axiom's STNG network. An engine gateway, providing isolation, is a good idea, though the ECI-100 doesn't officially support Evinrude (the officially supported integrations are listed here.) Your tank data should be connected directly into STNG, not on the engine side of any gateway. You should be fine to connect the engines and tank sensor(s) straight into the same network as the Axiom system. Just make sure than any NMEA2000 network has only a single point of power and exactly 2 terminators. You can see the STNG (our implementation of NMEA2000) reference manual at https://raymarine.app.box.com/s/2ulwt6ye...1787214721. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] ECI-100 compatibility with Etecs - dars padilla - 10-28-19, 05:56 AM
RE: [TG11] ECI-100 compatibility with Etecs - Tom - Raymarine - Moderator - 10-29-19 01:02 AM
|
User(s) browsing this thread: 1 Guest(s)