Raymarine forum / Raymarine Forums / NAVAIDS v / [DG] [DG] A75 plotter - Boat backwards

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] A75 plotter - Boat backwards
07-03-18, 01:23 AM (This post was last modified: 07-04-18 07:15 AM by Derek - Raymarine - Moderator.)
Post: #1
Jools Offline
Junior Member
**
 		Posts: 3
Joined: May 2018
Reputation: 0
[DG] A75 plotter - Boat backwards
Hi, the screen is showing the boat going backwards on my plotter, is there a simple fix? The plotter was installed by a 3rd party and I can’t see any calibration instructions when I download the manual? Thanks.
Find all posts by this user
Quote this message in a reply
07-04-18, 07:19 AM
Post: #2
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: [DG] A75 plotter - Boat backwards
Hi Jools

Thankyou for your enquiry.

The boat symbol direction is determined by the heading input to the system. If there is a compass input to your MFD, either from NMEA or from an autopilot, then check the compass on this device, since it is likely it will be wrong.

Please refer to this advice for further instructions and guidance

Recalibrate the compass input to the system and the boat symbol will display correctly.

regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication