e127 and ST60 Autopilot

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

e127 and ST60 Autopilot

08-04-16, 12:10 PM (This post was last modified: 08-08-16 01:52 PM by Chuck - Raymarine - Moderator.)

Post: #7

cbd@gov-consult.com Offline

Junior Member

Posts: 8
Joined: May 2016
Reputation: 0

RE: e127 and ST60 Autopilot

Chuck,
When entering a single waypoint (go to cursor for example) or starting an autoroute I have to repeatedly (over and over again) respond to the "change status" message on the screen until it stops appearing. It comes up multiple times even when going to a single "go to cursor" waypoint and loads of times when starting on a multi waypoint autoroute. Am I doing something wrong here??
Thanks!

« Next Oldest | Next Newest »

Messages In This Thread

e127 and ST60 Autopilot - cbd@gov-consult.com - 06-14-16, 09:17 AM

RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 06-14-16, 09:41 AM

RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 06-25-16, 07:25 AM

RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 06-27-16, 10:51 AM

RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 07-05-16, 12:48 PM

RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 07-05-16, 01:54 PM

RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 08-04-16 12:10 PM

RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 08-26-16, 08:43 AM

RE: e127 and ST60 Autopilot - cbd@gov-consult.com - 08-26-16, 02:16 PM

RE: e127 and ST60 Autopilot - Chuck - Raymarine - Moderator - 08-26-16, 02:52 PM

User(s) browsing this thread: 1 Guest(s)