Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Networking
08-19-16, 09:18 PM
Post: #1
Networking
Raymarine components

Gps 125
X5 GP tiller
Smart controller x5
St70 control head
C80

ShipModul miniplex 3 nmea and seatalk
Standard Horizon gx2200 w/ais

My question is on the seatalk parts can i use converter cables and plug them all into a backbone and uplink to c80? Or is the conversion done on the plug in module?
Find all posts by this user
Quote this message in a reply
08-23-16, 10:29 AM (This post was last modified: 08-23-16 10:30 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Networking
Welcome to the Raymarine Forum Dkdoyle,

It is not possible to use a SeaTalk to SeaTalkng Cable for the purpose specified. This cable is exclusively designed to permit interfacing products having a SeaTalkng communications interface which has additionally been designed to support SeaTalk communications (ex. i70, p70, p70R, i50, i60). If installing a powered and properly terminated SeaTalkng backbone, then a SeaTalk to SeaTalkng Converter (updated with v2.1 or later software) would need to be installed as a component of the backbone. The un-powered SeaTalk bus interfacing the Raystar 125 and C80 to one another would be in turn be interfaced to the yellow SeaTalk socket of the SeaTalk to SeaTalkng Converter.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us