Raymarine forum / Raymarine Forums / Multifunction Displays v / Transducer selection

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Transducer selection
12-22-16, 12:41 AM
Post: #7
DFMott Offline
Member
***
 		Posts: 60
Joined: Dec 2016
Reputation: 0
RE: Transducer selection
The part # for the adapter cable is 33-594-01. It is an AIRMAR cable. I checked resistance across pin 5 & 6 with my Fluke 175. It was zero. Could the installer of the prior C97 have used the wrong adapter cable? Is it the cable that provides the resistance or should I check the pins on the mix & match transducer cable?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Transducer selection - DFMott - 12-20-16, 01:51 PM
RE: Transducer selection - DFMott - 12-21-16, 01:15 AM
RE: Transducer selection - DFMott - 12-21-16, 01:39 PM
RE: Transducer selection - DFMott - 12-22-16 12:41 AM
RE: Transducer selection - DFMott - 12-23-16, 01:12 AM
RE: Transducer selection - DFMott - 12-29-16, 12:08 PM
RE: Transducer selection - DFMott - 12-30-16, 02:52 PM
RE: Transducer selection - DFMott - 01-01-17, 11:53 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication