Raymarine forum / Raymarine Forums / Multifunction Displays v / Transducer selection

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Transducer selection
12-23-16, 08:26 AM (This post was last modified: 12-23-16 09:45 AM by Chuck - Raymarine - Moderator.)
Post: #10
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Transducer selection
Don,

Should you have ordered the correct cable from Airmar, Inc., then it should not be necessary to perform any modification of the cable to permit it to be mated to the MFD. Should you not already have done so, then it is recommended that Airmar, Inc. be contacted to ensure that you have ordered the correct cable. Note that the diagram that I posted earlier shows a nine pin plug with four unused pins.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Transducer selection - DFMott - 12-20-16, 01:51 PM
RE: Transducer selection - DFMott - 12-21-16, 01:15 AM
RE: Transducer selection - DFMott - 12-21-16, 01:39 PM
RE: Transducer selection - DFMott - 12-22-16, 12:41 AM
RE: Transducer selection - DFMott - 12-23-16, 01:12 AM
RE: Transducer selection - Chuck - Raymarine - Moderator - 12-23-16 08:26 AM
RE: Transducer selection - DFMott - 12-29-16, 12:08 PM
RE: Transducer selection - DFMott - 12-30-16, 02:52 PM
RE: Transducer selection - DFMott - 01-01-17, 11:53 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication