Command Link interface
|
08-14-17, 03:27 PM
Post: #12
|
|||
|
|||
RE: Command Link interface
Angler Management,
Q. I'm assuming I should call Yamaha support if I'm not able to access all engine data on my MFD? At this time I can only see RPM, oil temp, pressure and fuel levels. No information is displayed regarding battery (alternator output I assume), etc... A. Possibly. Were a technician to tackle this issue, the technician would interface a NMEA 2000 analyzer (ex. Actisense NGT-1 w/NMEA Reader PC software) to determine what data is actually present on the SeaTalkng/NMEA 2000 backbone. Should the MFD not be displaying a supported engine data item for which data has been determined to be present, then Raymarine should be contacted. Should an expected data item not be present on the SeaTalkng/NMEA 2000 backbone as determined using such an analyzer, then the engine manufacturer should be contacted accordingly. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Command Link interface - Angler Management - 06-28-17, 01:50 PM
RE: Command Link interface - Chuck - Raymarine - Moderator - 06-28-17, 03:14 PM
RE: Command Link interface - Angler Management - 06-28-17, 04:07 PM
RE: Command Link interface - Chuck - Raymarine - Moderator - 06-29-17, 08:24 AM
RE: Command Link interface - Angler Management - 07-18-17, 12:43 AM
RE: Command Link interface - Chuck - Raymarine - Moderator - 07-18-17, 08:04 AM
RE: Command Link interface - Angler Management - 07-18-17, 10:12 AM
RE: Command Link interface - Chuck - Raymarine - Moderator - 07-18-17, 10:37 AM
RE: Command Link interface - steaua1986 - 08-10-17, 11:08 AM
RE: Command Link interface - Chuck - Raymarine - Moderator - 08-14-17, 01:30 PM
RE: Command Link interface - Angler Management - 08-14-17, 01:48 PM
RE: Command Link interface - Chuck - Raymarine - Moderator - 08-14-17 03:27 PM
|
User(s) browsing this thread: 1 Guest(s)