Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
change to E80 from C120
07-25-17, 09:07 AM (This post was last modified: 07-25-17 12:40 PM by Chuck - Raymarine - Moderator.)
Post: #6
RE: change to E80 from C120
Thank you again, Chuck,

The start up problem with the GPS connected has become more intermittent - now starts much of the time with the GPS connected. Curiously, if the start up fails, if I disconnect the GPS data wire (yellow), the E80 will then start up, and if I then reconnect the GPS yellow after the E80 is up it will recognize the fix and carry on happily.

I have run the Verify Card diagnostics several times with the results:
BP2 checked 2130 errors 0
NV2 checked 10,000,000 plus (Mised end of test) errors 59
Reports 59 errors each time I run it (takes a long time)
Q: I am wondering if this is indicative of some sort of internal problem in the E80?

I will do a power on factory reset (again). I understand that this reset is more complete than the one from the E80 menu.

Q: I am also wondering if a software reinstall might help?

I will try the NMEA interface and Raystar 150 if the problem persists. My piggy bank is getting light though.

Kind regards,
Don
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
change to E80 from C120 - Don Guy - 07-21-17, 10:24 AM
RE: change to E80 from C120 - Don Guy - 07-21-17, 12:31 PM
RE: change to E80 from C120 - Don Guy - 07-21-17, 12:53 PM
RE: change to E80 from C120 - Don Guy - 07-25-17 09:07 AM
RE: change to E80 from C120 - Don Guy - 07-27-17, 10:48 AM
RE: change to E80 from C120 - Don Guy - 07-27-17, 11:14 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)