Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Triducer replacement for Tacktick mn30
09-11-17, 01:18 PM
Post: #1
Triducer replacement for Tacktick mn30
I have a Tacktick mn30 system installed in 2011. The knotmeter has started showing zero all the time, even though the wheel is spinning freely.

Any options apart from getting a new transducer?

If replacing the transucer, should I get the DST800 smart transducer or the DST800 analogic? The current transducer is connected to the hull transmitter with separate wires for depth and speed.
Find all posts by this user
Quote this message in a reply
09-12-17, 01:49 PM (This post was last modified: 09-12-17 01:52 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Triducer replacement for Tacktick mn30
Welcome to the Raymarine Forum hakongs,

While the TackTick hull transmitters are designed to function with the T910, T911, and T912 transducer, Raymarine's analog instruments transducers may also be used with TackTick hull transmitters. Smart transducers should not be used with TackTick instruments, as the TackTick instruments will be unable to calibrate them. In cases of a failing speed sensor within a T910 or T911, most will simply elect to leave the currently installed T910 or T911 housing in place, purchase another T910 or T911, extract the failed sensor from its housing then then replace it with the sensor from the newly purchased transducer.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)

Contact Us