Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(DG) Auto Pilot Bleeding
02-02-18, 09:20 AM (This post was last modified: 02-02-18 09:21 AM by Derek - Raymarine - Moderator.)
Post: #2
RE: (DG) Auto Pilot Bleeding
Hi Wonderly

Thank you for your enquiry.

We would suggest bleeding the Steering cylinder first, then the pump.

The pump is easily bled by selecting AUTO on the autopilot and initiating a Starboard turn, ( 2 x +10 course change buttons), then turning the boat's steering wheel continuously to port - this will mean the the rudder/ steering leg remains stationary, BUT the hydraulic fluid is pumped round in a circuit between the autopilot pump and the steering helm pump, thereby bringing any remaining air bubbles up to the helm pump, where they are safely ventilated.

Keep an eye on the fluid level in the helm pump reservoir to make sure it does not drop too low and allow air back into the system.

regards
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
(DG) Auto Pilot Bleeding - Wonderly - 02-01-18, 09:04 PM
RE: (DG) Auto Pilot Bleeding - Derek - Raymarine - Moderator - 02-02-18 09:20 AM
RE: (DG) Auto Pilot Bleeding - Wonderly - 02-03-18, 10:43 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)