Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raymarine Backbone to B&G
03-30-16, 05:28 PM
Post: #1
Raymarine Backbone to B&G
I have a Ray backbone connected to Wind, AP, Depth and Speed

What do I need to add to connect my B&G Zeus?

Thank You
Find all posts by this user
Quote this message in a reply
03-31-16, 11:00 AM (This post was last modified: 03-31-16 11:06 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Raymarine Backbone to B&G
Welcome to the Raymarine Forum 473Clipper,

Raymarine offers SeaTalkng to DeviceNet Male (A06046) and SeaTalkng to DeviceNet Female adapter cables (A06045) as well as Stripped End Spur cables (A06044) to support interfacing third party NMEA 2000 devices as spurs to the SeaTalkng network backbone. Should a backbone already exist for the B&G system, then one end of the SeaTalkng backbone may be married to one end of the B&G backbone by splicing the SeaTalkng backbone cable to the B&G backbone cable. The combined backbone should be terminated as if it were a single backbone and should be powered via a single power insertion point located at the approximate mid-point of the combined backbone's LEN load.
Visit this user's website Find all posts by this user
Quote this message in a reply
03-31-16, 04:48 PM (This post was last modified: 04-01-16 01:33 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: Raymarine Backbone to B&G
Thank You
Find all posts by this user
Quote this message in a reply
04-01-16, 01:34 PM
Post: #4
RE: Raymarine Backbone to B&G
You're welcome.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us