(DG) E80 Seatalk2 output to ST60+
|
04-20-18, 09:08 AM
(This post was last modified: 04-20-18 09:13 AM by Derek - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: (DG) E80 Seatalk2 output to ST60+
Hi Brettbc
Thank you for your enquiry below. ST60+ uses SeaTalk, not SeaTalk2 and so the ST60+ should be connected to the SeaTalk connection on the rear of the E80. The DSM connection uses a very different data protocol and so that cannot be used either. Please see the connector panel below . . . The SeaTalk connector on the E80 uses a round plug, see below This is the correct means to connect the ST60+tothe E80 and willenable the ST60+to share depth information from the DSM via the E80. Regards |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
(DG) E80 Seatalk2 output to ST60+ - Brettbc - 04-20-18, 08:34 AM
RE: (DG) E80 Seatalk2 output to ST60+ - Derek - Raymarine - Moderator - 04-20-18 09:08 AM
RE: (DG) E80 Seatalk2 output to ST60+ - Brettbc - 04-21-18, 09:05 AM
RE: (DG) E80 Seatalk2 output to ST60+ - Derek - Raymarine - Moderator - 04-23-18, 06:53 AM
|
User(s) browsing this thread: 1 Guest(s)