Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Ray55 and Raymic cable
05-06-18, 05:11 PM (This post was last modified: 05-09-18 03:30 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Ray55 and Raymic cable
So I purchased a used Ray55 VHF and the Raymic. The VHF is an 8 in female and the raymic is a 10 pin female. The extension cable are all one male / one female?? What cable do I need to connect the two??

Thanks!

GC
Find all posts by this user
Quote this message in a reply
05-09-18, 03:41 PM (This post was last modified: 05-20-19 12:09 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Ray55 and Raymic cable
Welcome to the Raymarine Forum GC,

Raymarine has produced two versions of the RayMic (A46051/A46052 and A80289). Of these, only the A46051 RayMic was designed to be interfaced to a Ray55 or Ray218 VHF radio. The A46052 RayMic was designed to be interfaced to a Ray55e or Ray218e VHF radio. The A80289 RayMic cannot be used with a Ray55/Ray55e/Ray218/Ray218e VHF radio. The panel mount cable supplied with the Ray55/Ray55e/Ray218/Ray218e featured a socket which was designed to be mounted through panel. The A46051 or A46051 RayMic would then connect to the this socket. The other end of the panel mount cable was designed to be interfaced to the corresponding cable exiting from the rear of the Ray55/Ray55e/Ray218/Ray218e VHF radio's chassis. Raymarine offered the A46055 5m Raymic Extension Cable and the A46056 10m Raymic Extension Cable for use with these products.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us