[CA] [CA11] Quantum 2 to Axiom

[Chuck - Raymarine - Moderator]

Gregg,

Please verify that the Axiom MFDs have been updated with LightHouse 3 v3.4.66 or later software, as this LightHouse 3 software is required when interfacing with a Quantum 2 radome. If not, the software within the Axiom MFDs should be updated accordingly. Should the problem persist after having updated the MFD's software, then it is recommended that the power circuit supplying the radome be switched OFF and then ON again to wake up the radome. If interfaced via Ethernet (ex. Digital Radar Cable, Quantum Data Cable), the MFD will be unable to communicate via Wi-Fi with a Quantum or Quantum 2 radome. Should the MFD be unable to establish communications with the radome within 10 minutes of having cycled power to the radome, then it would be recommended that the power circuit supplying the radome be switched OFF and ON again to wake up the radome once again. Should the problem persist, then it is recommended that power be checked at the A80308 Quantum Adapter Cable. If power is verified at the Quantum 2 radome, then any user data (waypoints, routes, tracks, etc.) be backed up and configuration settings noted. After doing so, then it would be recommended that a Factory Reset (MOME->SETTINGS->THIS DISPLAY->FACTORY RESET) be commanded to each Axiom MFD and that the system then be tested after the power circuit supplying the radome be switched OFF and ON again.