Raymarine forum / Raymarine Forums / Instruments v / [DG] [DG] Interfacing ST2000+ and i60

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] Interfacing ST2000+ and i60
06-27-18, 07:40 AM
Post: #2
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: [DG] Interfacing ST2000+ and i60
Hi markyfff

Thankyou for your enquiry

the i60 can operate in SeaTalk mode or in STng mode, ( but not both at the same time).

We suggest use the i60 in SeaTalk mode and it can then connect direct to the SeaTalk connections on the ST2000+ tiller pilot socket.

Use the cable that has the White STng connector one end and the flat 3 pin plug the other end. Remove the flat plug and bare the wires back. Connect the red wire to the Red SeaTalk wire, conenct the yellow to the yellow SeaTalk wire and connect the Black to the bare /Shield SeaTalk wire.

When power is applied to the ST2000+ plug, the i60 should power up
Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [DG] Interfacing ST2000+ and i60 - Derek - Raymarine - Moderator - 06-27-18 07:40 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication