Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST7002 does work with the E22158 converter
04-14-16, 02:09 PM (This post was last modified: 04-14-16 02:40 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: ST7002 does work with the E22158 converter
Chuck,
Thanks for your prompt reply.
I either missunderstood the bellow instructions received from this forum or it was incomplete. I did exactly as it reads bellow.
quote:
"For the connection of the ST7002, that was connected via Seatalk interface the new c125 does not have Seatalk interface any longer it has the new Seatalk NG interface, what you would need is a E22158 Seatalk to Seatalk NG converter and connect the ST7002 to the yellow port on the converter and connect the converter to the Seatalk NG port on the c125."
unquote

Question that was not aswered: should I connect the ST7002 to the SX pilot via seatalk (I undertsand It will not go to the MFD via the seatalk ng network) but I will still have control on the auto pilot SX device,and then connect the SX piltot to the MDF via the seatalk ng net work?b it seems easier than going to the whole
updating process.
Thank you very much,
Joaquim
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST7002 does work with the E22158 converter - joaquim prado - 04-14-16 02:09 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us