Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ST4000+ starts hunting at higher cruising speeds
07-23-18, 06:31 PM (This post was last modified: 08-16-18 08:45 AM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] ST4000+ starts hunting at higher cruising speeds
I am brand new to the Forum but have an old Autohelm that came with a cruising sailboat we purchased two years ago. (38 feet)
After calibrating the compass with <5* of variance I was excited to get the vessel moving forward in calm seas up to her cruising speed of 6.5 knots.
Between 3 and 4 knots of making way the pilot held fine with the drive making slight adjustments. When I reached 5.5 knots the boat starts veering starboard/comes back to port past centre/continues to port then comes all theway back again. At this point I need to take control back and put into Standby mode.
Reading the manual many times I have played with rudder gain (left it at 6) and also made sure there was no metal objects close to the compass.
Any thoughts?
I am crossing my fingers there is a command fix for this.
Cheers.
Greg McKenzie
Find all posts by this user
Quote this message in a reply
07-27-18, 12:37 AM (This post was last modified: 08-16-18 08:45 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [TG11] ST4000+ starts hunting at higher cruising speeds
Hello Greg,

I assume this is a Wheel system rather than ST4000+ Tiller? If wheel, does it have a rudder-position sensor (do you see rudder-angle on the display when in Standby)?

The ST4000+ wasn't as clever as the modern pilots and reasonably often behaved like that if on a wheel-steered boat with no rudder-reference. Later 4000+ Wheels were bundled with the rudder-reference for this reason. I would guess that you will see a lot of benefit from a rudder-reference, part M81105.

The 4000+ often wouldn't recognise a newly-installed rudder-reference: if this happens, go into Dealer Calibration (https://raymarine.app.box.com/s/nwf2s5ha.../720705051) and change the Pilot Type from 4000 Wheel to something like 5000 Hydraulic, save-and-exit, power-cycle, change back to 4000 Wheel, save-and-exit, power cycle and you should be good to go.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
08-15-18, 01:42 PM (This post was last modified: 08-16-18 08:45 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [TG11] ST4000+ starts hunting at higher cruising speeds
Thanks for advice Tom - - will explore this option. Greg
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)