Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] Type 2 Linear Drive Clutch Surfaces
09-25-18, 06:13 PM (This post was last modified: 09-26-18 10:52 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG] Type 2 Linear Drive Clutch Surfaces
I have just disassembled my linear drive and found that the drive clutch coil and clutch assemble surfaces look like there has been some slipping and scratching of the suface. Should I clean up the clutch coil and clutch assemble surfaces or should I replace the parts? Thanks
Find all posts by this user
Quote this message in a reply
09-26-18, 10:54 AM
Post: #2
RE: [DG] Type 2 Linear Drive Clutch Surfaces
Hi powfield

Welcome to the forum,

The clutch faces should be carefully cleaned up with fine emery or wet and dry paper, degreased and left smooth and clean. This should be fine and will recover the friction plates in most circumstances, unless the scoring is deep, in which case, replace the parts
Thanks
Derek
Find all posts by this user
Quote this message in a reply
09-27-18, 02:31 PM
Post: #3
RE: [DG] Type 2 Linear Drive Clutch Surfaces
Thanks Derek
Find all posts by this user
Quote this message in a reply
09-28-18, 06:58 AM
Post: #4
RE: [DG] Type 2 Linear Drive Clutch Surfaces
Hi powfield,

You're welcome

Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)