Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] AIS 700 stopped transmitting positions
10-08-18, 07:39 PM (This post was last modified: 10-10-18 02:28 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] AIS 700 stopped transmitting positions
For the last several days my AIS 700 stopped transmitting my boat position.

I can see two error messages in proAIS2:

1 AIS: Tx malfunction
69 AIS: Low forward power

See also the attached screen shot. GNSS status looks good.

What is the likely culprit?
Find all posts by this user
Quote this message in a reply
10-10-18, 02:35 PM
Post: #2
RE: [CA11] AIS 700 stopped transmitting positions
Welcome to the Raymarine Forum Nokay,

Please click here to view a FAQ addressing this subject. Should the referenced voltage test not indicate a power issue and whereas the ProAIS2 software is not reporting VSWR, it would be recommended that the VHF antenna/cable assemble be tested with a VSWR meter. Should the VHF antenna/cable assembly's VSWR be within the range specified within the referenced FAQ, then the AIS700 should be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us