Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Ev100 Proper Torque for BSP Adapters to Pump

Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Ev100 Proper Torque for BSP Adapters to Pump
11-13-18, 10:10 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump
Welcome to the Raymarine Forum bwconquest21,

Like most such hydraulic or threaded plumbing fittings used within an automobile or within one's home, no torque has been specified for the BSP to NPT adapters included the hydraulic pump. One would typically tighten these fittings with a box wrench until the fitting has been firmly tightened. Following installation, connections to the pump would be examined for signs of leakage and then further tightened if any signs of leakage are observed. I did find a web page on related torque for hydraulic fittings on a hydraulic product manufacturer's web site which may be viewed here.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Ev100 Proper Torque for BSP Adapters to Pump - Chuck - Raymarine - Moderator - 11-13-18 10:10 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication