Raymarine forum / Raymarine Forums / Networking / System Integration v / [DG] [DG11] Adding an RMK10 to two axioms - switch not powering on

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Adding an RMK10 to two axioms - switch not powering on
03-07-19, 05:41 AM
Post: #10
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: [DG11] Adding an RMK10 to two axioms - switch not powering on
Hi WStandis,

I think the crossover coupler suggestion is irrelevant to be honest, the issue is more likely a faulty RayNet cable on the RMK10. Have you tried connecting the RMK10 to the HS5 network switch using one of the cables from an AXIOM - since the AXIOMs connect correctly to the HS5, using one of their cables will identify if the RMK10 cable is faulty.

Also check the voltage of the power to the RMK10, make sure it is a good 12.5V and there is enough current available.

Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [DG11] Adding an RMK10 to two axioms - switch not powering on - Derek - Raymarine - Moderator - 03-07-19 05:41 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication