[CA] [CA11] Axiom Pro RVX and Transducer Compatability

[jdb17]

Hi Chuck,

Thank you very much for your insight, with your input we made a purchase of a new electronics system for our boat. We ended up going with a pair of Axiom Pro RVXs, Quantum Doppler Radar, the RV-200, the B265LM, AIS, and so on. We held off on the CP570 for now, but are considering it if the rendering latency is an issue for us.

The problem we have now though, is the flat spot we intended to mount the RV-200 on our hull is too small to carry the RV-200. The technician we are using to handle of the install told us we could use a single RV-220 mounted on one side and get similar results.

Q1 - Can a single RV-220 actually provide the full suite of RV features, down vision, real vision 3D, side scan, etc?

Q2 - It seems after doing some reading, the RV-220 requires a pair, both port and starboard to be run through the Y-cable. Is this indeed true, that we need both Port and Starboard 'ducers to make this work?

Q3 - If a single RV-220 is installed, would it result in just a blind side, or would the functionality be severely reduced?

--

Again, appreciate your help Chuck,

-Jon