[DG] [DG11] ST60+

[brooksnajr@yahoo.com]

So thanks for getting bake to me but, I must ask I did some additional research on this topic and I found another answer by one of your moderators back in May of 2018 and someone else asked a similar question and here is his response:
"
ST60/ST60+ use Seatalk1, not SeatalkNG. You need a Seatalk1-SeatalkNG convertor (part E22158 for a kit, R52131 for the bare convertor only, see http://www.raymarine.com.au/view/?id=400...7&col=1597 for details). The ST1-STNG convertor becomes part of the STNG backbone (connected in via a backbone cable), whilst you connect the supplied ST1 cable to any free ST1 port in the existing ST60 system.

You need a single power supply to the combined ST1-STNG network: the convertor passes this power through. You will already have power on ST1, so don't also supply power on the STNG side (do not connect the STNG red cable.) The ACU100 will require its own power as it draws too much to be powered from STNG, but it won't pass that power through to STNG (larger ACUs can, the ACU100 won't.)

Regards,
Tom"

is this not accurate?

Thanks again, bub