The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] e127/ B744 can't see fish
08-30-19, 01:00 PM (This post was last modified: 09-23-19 03:55 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] e127/ B744 can't see fish
Hi,

I've had this unit installed on my boat for about 4 years. I've never been able to see fish unless they're big and right under the boat (albacore). I can see the bottom just fine, even at speed but after watching countless hours of video's and countless hours of trying to adjust everything, I never seem to have any luck. I've also just left everything on Auto and still no luck. I know there are fish there because my catch rate has been good. Once I adjust the sensitivity up high enough to see the downrigger [censored] (12 lbs at 55 feet) the screen is so cluttered up I wouldn't know a fish if I saw it. I'm expecting to see 5-30 lb salmon.

I operate in saltwater in the Pacific Northwest.

Can you provide any clues as to what is wrong?

Boat is a Shamrock Mackinaw 270 straight shaft. Transducer is mounted upstream of the shaft and has a high speed fairing block.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] e127/ B744 can't see fish - Captain Starbucks - 08-30-19 01:00 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)