[CA] [CA11] New Axiom user questions
|
10-08-19, 11:19 AM
(This post was last modified: 10-08-19 01:26 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] New Axiom user questions
I have just installed an Axiom 9 with a RV100 transducer. Put it on the water yesterday for the first time and seem to be getting interference on the sonar. Attached are some screenshots. It looks like I am leaving a trail of fish on the Realvision and the sonar isn't clean at all. The gain was set to auto. There were no other devices on that could cause interference and I did turn off the engine but there was no change. On installation I installed the drain wire on the negative bus with the negative power lead. Any advice on what is causing this issue?
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] New Axiom user questions - RockBottom - 10-08-19 11:19 AM
RE: [CA11] New Axiom user questions - Chuck - Raymarine - Moderator - 10-08-19, 03:49 PM
RE: [CA11] New Axiom user questions - RockBottom - 10-28-19, 06:43 AM
RE: [CA11] New Axiom user questions - Chuck - Raymarine - Moderator - 10-28-19, 08:17 AM
RE: [CA11] New Axiom user questions - RockBottom - 10-28-19, 08:22 AM
RE: [CA11] New Axiom user questions - Chuck - Raymarine - Moderator - 10-28-19, 09:01 AM
|
User(s) browsing this thread: 1 Guest(s)