Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Autopilot Upgrade
10-10-19, 07:07 PM (This post was last modified: 10-11-19 12:25 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Autopilot Upgrade
Hello. Looking to upgrade the autopilot on my 2006 Sea Ray 340 V Drive with Seastar steering. Two questions. I would like to know if I can keep my current hydraulic pump from the ST6001 and S2G 12091 system, and just replace with the new ACU and Sensor Core. Also, would like to know if I can use the ACU 150 and EV1, or do i have to go with the ACU 200 and the EV2?
Find all posts by this user
Quote this message in a reply
10-11-19, 12:33 PM
Post: #2
RE: [CA11] Autopilot Upgrade
Welcome back to the Raymarine Forum Barry,

Q1. I would like to know if I can keep my current hydraulic pump from the ST6001 and S2G 12091 system, and just replace with the new ACU and Sensor Core.
A1. Yes.

Q2. would like to know if I can use the ACU 150 and EV1, or do i have to go with the ACU 200 and the EV2?
A2. An EV-2 CCU would not be applicable to an autopilot for this system ... an EV-1 CCU would need to be included. If an M81120 Type 1 12v Hydraulic Pump (examine label affixed to the pump) was installed and should the vessel feature a 12VDC power distribution system, then an ACU150 may be used. The EV-1 CCU, ACU150, p70RS, and Evolution Cabling Pack are included within the T70407 EV-150 Core Pack.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us