+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Multifunction Displays (/forumdisplay.php?fid=120)
+--- Thread: [LW] [LW11] Axiom Pro MFD, no Tempsensor-readings (/showthread.php?tid=10557)
[LW11] Axiom Pro MFD, no Tempsensor-readings - JanneHson - 02-18-20 03:52 AM
Hello,
I have a problem to get any temperature readings in my Axiom Pro 9" MFD from Airmar dst800 triducer
System is Airmar dst 800 triducer connected to Raymarine Itc 5 converter, connected to seatalk backbone Cable to seatalkng converter plint to Axiom Pro MFD and also ST60 instruments
Everything seems ok, i have checked airmar temp sensor = ok
Itc5 Cables connected i right colors from triducer = ok
Itc5 led = ok
Speed info in MFD = ok
Deep info in MFD = ok
But Temp info = 0,0 (it should be about 12 deegres when i tested)
I cant find any sonar menu to enable temp sensor ?? (if that is the problem ?)
Please any idea ?
Regards /Janne
RE: [TG11] Axiom Pro MFD, no Tempsensor-readings - Tom - Raymarine - Moderator - 02-25-20 12:49 AM
Hello Janne,
To confirm that the temperature data (0,0) is coming from the DST800, what happens when you disconnect brown or white from the ITC5? Does temperature go to dashes ( -.- degrees)?
Can you measure the resistance on the DST800 brown and white wires, when disconnected from the ITC5? At 12 degrees it should read something around 13-15 kOhms, but if there's a problem with the DST's thermistor then it will read something well outside this range.
Is there any depth transducer connected to the Axiom Pro?
Regards,
Tom