+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Networking / System Integration (/forumdisplay.php?fid=21)
+--- Thread: [TG] Raystar 125 GPS seatalk and NMEA (/showthread.php?tid=11115)
Raystar 125 GPS seatalk and NMEA - AndrewP - 05-01-20 10:08 PM
I am adding a E90W plotter beside my old system that includes a Pathfinder RL70C and a Raystar 125 GPS receiver connected by SeaTalk.
I would like to split the GPS data separately to both units without networking them. My question is, can I leave the SeaTalk connection in place and simply run an NMEA 0183 connection from the R125 wires to the NMEA port on the E90W? Or do I need to replace the SeaTalk cabling to the RL70C with NMEA wiring from the R125? Advice much appreciated.
RE: Raystar 125 GPS seatalk and NMEA - Tom - Raymarine - Moderator - 05-05-20 12:33 AM
Hello AndrewP,
You don't need to go to the complexity of either of these changes: just connect all 3 devices together with Seatalk, that's fine. Avoid NMEA083 if at all possible, it's horrible. There is no problem having multiple chartplotters from different generations in the same Seatalk network.
Just make sure that you only have a single point of power for your single combined Seatalk network, so if you're joining an existing E90W network and RL70C network, make sure you remove the power supply from one or the other so that you don't double-up.
Regards,
Tom