+- Raymarine forum (http://forum.raymarine.com)
+-- Forum: Raymarine Forums (/forumdisplay.php?fid=1)
+--- Forum: Radar (/forumdisplay.php?fid=125)
+--- Thread: 4KW SHD RADAR SOFTWARE UPDATE ISSUE (/showthread.php?tid=1160)
4KW SHD RADAR SOFTWARE UPDATE ISSUE - John Pecora - 06-15-16 10:59 AM
Hi Tech,
I have just updated my E125 to v17. However, my radar will not update; it has v.08 & the download (via WiFi) lists v2.25 as available. All other connected network devices updated successfully. The download page indicates upgrade failed & to power-up radar (which was powered-up during the install). Strangely, after this, the master MFD radar window shows radar ID as 08001 while the slave MFD shows ID 20136. At that point I am not able to power-up the radar unless I cycle power to the VCM100, then I'm able to go to the slave unit radar menu & change the radar from 20136 to 08001 & at that point all function fine, just that I cannot do the update.
VCM100 LED indicators:
On - Green Solid
Fault - Off
Sleep - Off
Thanks,
John
RE: 4KW SHD RADAR SOFTWARE UPDATE ISSUE - John Pecora - 06-15-16 04:33 PM
Forum:
Tech has advised that this is normal: When v17 is downloaded the upgrade for 4kw SHD radars should not be installed if your radar is Model E52081E—that is, it begins & ends with an “Eâ€. The current software for this model is v.08.
Tech: Please correct this if I have misstated anything here.
Regards,
John
RE: 4KW SHD RADAR SOFTWARE UPDATE ISSUE - Chuck - Raymarine - Moderator - 06-16-16 08:30 AM
John,
Thanks for sharing this with the Forum. The information within your last post appears correct.